IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual page 177

To remove an IBM virtual media key, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 123.
2. If the system-board tray is installed in a chassis, remove it (see "Removing the
system-board tray from a 2U chassis" on page 126 or "Removing the
system-board tray from a 3U chassis" on page 128).
3. If an expansion enclosure is installed, remove it (see "Removing an expansion
enclosure from a system-board tray" on page 131); otherwise, remove the
system-board tray cover (see "Removing the system-board tray cover" on page
125).
4. Move the retention clip away from the virtual media key and pull the key from
the connector.
5. If you are instructed to return the virtual media key, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Chapter 5. Removing and replacing server components
161