Table of Contents
Advertisement
1. Follow any special handling and installation instructions that come with the
2. Tilt the battery so that you can insert it into the socket on the side opposite the
3. Press the battery down into the socket until it clicks into place. Make sure that
4. If you removed the PCIe riser-card assembly, install it (see "Installing a PCIe
5. Install the expansion enclosure, if you removed one (see "Installing an
6. Install the system-board tray in the chassis (see "Installing the system-board
7. Turn on the system-board tray and run the Setup utility. Set configuration
Removing and installing a hard disk drive
The following section describes how to remove and replace 2.5-inch hot-swap hard
disk drives and 3.5-inch simple-swap hard disk drives.
Removing a 2.5-inch hot-swap hard disk drive
To remove a 2.5-inch hot-swap hard disk drive, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Rotate the drive tray handle of the drive that is to be removed to the open
3. Grasp the drive handle and pull the drive out of the bay.
battery.
battery clip.
the battery clip holds the battery securely.
riser-card assembly in the system-board tray" on page 172).
expansion enclosure on a system-board tray" on page 132); otherwise, install
the system-board tray cover (see "Installing the system-board tray cover" on
page 125).
tray in a 2U chassis" on page 127 or "Installing the system-board tray in a 3U
chassis" on page 129).
parameters as needed (see "Using the Setup utility" on page 214 for
information).
on page 123.
position.
Chapter 5. Removing and replacing server components
139
Advertisement
Table of Contents
