Removing a storage enclosure
To remove a storage enclosure, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the storage enclosure is installed on a system-board tray, remove it (see
3. Carefully set the storage enclosure on a flat, static-protective surface.
4. Make a note of where the hard disk drives are installed; then, remove them.
5. Note the cable routing; then, remove the hard disk drive bracket and cable
6. If you are instructed to return the storage enclosure, follow all packaging
180
System x iDataPlex dx360 M2: Problem Determination and Service Guide
on page 123.
"Removing an expansion enclosure from a system-board tray" on page 131).
Place them on a static-protective surface or install them in the new storage
enclosure (see "Removing and installing a hard disk drive" on page 139).
assembly (see "Removing and installing a one-bay or four-bay hard disk drive
bracket and cable assembly" on page 168).
instructions, and use any packaging materials for shipping that are supplied to
you.