Removing A Front-Panel Assembly - IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual

Removing a front-panel assembly

To remove the front-panel assembly, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the system-board tray is installed in a chassis, remove it (see "Removing the
3. If an expansion enclosure is installed, remove it (see "Removing an expansion
4. Note the cable routing and where each cable is connected and disconnect the
5. Press the release tab and slide the front-panel assembly away from the front of
6. Note the cable routing and disconnect the front-panel assembly cables from the
7. Open the cable retention latches and carefully pull the assembly and cables
8. If you are instructed to return the front-panel assembly, follow all packaging
192
System x iDataPlex dx360 M2: Problem Determination and Service Guide
on page 123.
system-board tray from a 2U chassis" on page 126 or "Removing the
system-board tray from a 3U chassis" on page 128).
enclosure from a system-board tray" on page 131); otherwise, remove the
system-board tray cover (see "Removing the system-board tray cover" on page
125).
cables that are near the front-panel assembly to improve accessibility.
the system-board tray.
system board and power-supply paddle card.
from the system-board tray.
instructions, and use any packaging materials for shipping that are supplied to
you.