1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the system-board tray is installed in a chassis, remove it (see "Removing the
3. If a storage enclosure is installed, remove it (see "Removing an expansion
4. Remove the screw that secures the PCIe riser-card assembly to the
5. Pull the PCIe riser-card assembly out of the riser-card slot on the system board.
6. If an adapter is installed on the PCIe riser-card assembly, remove it (see
7. If you are instructed to return the PCIe riser-card assembly, follow all packaging
Installing a PCIe riser-card assembly in the system-board tray
To install a PCIe riser-card assembly in the system-board tray, complete the
following steps.
172
System x iDataPlex dx360 M2: Problem Determination and Service Guide
on page 123.
system-board tray from a 2U chassis" on page 126 or "Removing the
system-board tray from a 3U chassis" on page 128).
enclosure from a system-board tray" on page 131); otherwise, remove the
system-board tray cover (see "Removing the system-board tray cover" on page
125).
system-board tray and save it for future use.
"Removing an adapter from the system-board tray" on page 152).
instructions, and use any packaging materials for shipping that are supplied to
you.