IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual page 168

Installing an adapter in the I/O enclosure
To install a PCIe adapter in the I/O enclosure, complete the following steps.
I/O enclosure
1. Touch the static-protective package that contains the adapter to any unpainted
2. See the documentation that comes with the adapter to determine whether you
3. Align the adapter with the PCIe slot on the riser-card assembly; then, press the
4. If you disconnected cables when you removed the adapter, reconnect the
5. Install the PCIe adapter bay cover on the I/O enclosure (see "Installing the PCIe
6. Install the I/O enclosure on the system-board tray (see "Installing an expansion
7. Install the system-board tray in the chassis (see "Installing the system-board
Removing an adapter from the system-board tray
To remove a PCIe adapter from the system-board tray, complete the following
steps.
152
System x iDataPlex dx360 M2: Problem Determination and Service Guide
PCI slots
PCIe bay cover
metal surface on the outside of the system-board tray; then, remove the adapter
from the package. Avoid touching the components and gold-edge connectors on
the adapter.
must set any jumpers or switches.
adapter into the slot.
cables.
adapter bay cover" on page 143).
enclosure on a system-board tray" on page 132).
tray in a 2U chassis" on page 127).
Note: To complete the installation of the PCIe adapter, see the documentation
that comes with the adapter for device-driver and configuration
information.
Slot cover
Tabs
End of
Bay cover
Adapter
Screws