IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual page 98

Table 3. Integrated management module error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 4, "Parts listing," on page 109 to determine which components are customer replaceable
units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Message
DHCP[%1] failure, no IP
address assigned.
(%1 = IP address,
xxx.xxx.xxx.xxx)
ENET[0] DHCP-HSTN=%1,
DN=%2, IP@=%3, SN=%4,
GW@=%5, DNS1@=%6.
(%1 =
CIM_DNSProtocolEndpoint.
Hostname;
%2 =
CIM_DNSProtocolEndpoint.
DomainName; %3 =
CIM_IPProtocolEndpoint
IPv4Address;
%4 =
CIM_IPProtocolEndpoint.
SubnetMask;
%5 = IP address,
xxx.xxx.xxx.xxx;
%6 = IP address,
xxx.xxx.xxx.xxx)
ENET[0]
IP-Cfg:HstName=%1,
IP@%2, NetMsk=%3,
GW@=%4. (%1 =
CIM_DNSProtocolEndpoint.
Hostname; %2 =
CIM_StaticIPSettingData.
IPv4Address; %3 =
CIM_StaticIPSettingData.
SubnetMask; %4 =
CIM_StaticIPSettingData.
DefaultGatewayAddress)
Ethernet Data Rate modified
from %1 to %2 by user %3.
(%1 = CIM_Ethernet
Port.Speed; %2 =
CIM_EthernetPort.Speed;
%3 = user ID)
82
System x iDataPlex dx360 M2: Problem Determination and Service Guide
Severity Description
Info A DHCP server has failed to assign
an IP address to the IMM.
Info The DHCP server has assigned an
IMM IP address and configuration.
Info An IMM IP address and
configuration have been assigned
using client data.
Info A user has modified the Ethernet
port data rate.
Action
1. Make sure that the network
cable is connected.
2. Make sure that there is a DHCP
server on the network that can
assign an IP address to the
IMM.
No action; information only.
No action; information only.
No action; information only.