Table of Contents
Advertisement
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the chassis that contains the power supply is installed in an iDataPlex rack,
3. Remove the top cover (see "Removing the 2U chassis fan-assembly top cover"
4. Remove the fan assembly (see "Removing the 2U chassis fan assembly" on
5. Press the power-supply release latch and push the power supply toward the
6. Carefully pull the power supply out through the front of the chassis.
7. If you are instructed to return the power supply, follow all packaging instructions,
Installing a power supply in a 2U chassis
To install the power supply in a 2U chassis, complete the following steps.
1. Touch the static-protective package that contains the power supply to any
2. Insert the power supply into the front of the chassis.
3. Carefully guide the power supply into the guides at the left-rear corner of the
4. Install the fan assembly (see "Installing the 2U chassis fan assembly" on page
5. Install the top cover (see "Installing the 2U chassis fan-assembly top cover" on
6. Install the chassis in the iDataPlex rack (see "Installing the 2U chassis in a Type
Removing a power supply from a 3U chassis
To remove a power supply from a 3U chassis, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
174
System x iDataPlex dx360 M2: Problem Determination and Service Guide
on page 123.
remove it (see "Removing the 2U chassis from a Type 7825 iDataPlex rack" on
page 186).
on page 135).
page 133).
front of the chassis.
and use any packaging materials for shipping that are supplied to you.
Power supply
unpainted metal surface on the outside of the chassis; then, remove the power
supply from the package.
chassis until the release latch clicks into place.
134).
page 135).
7825 iDataPlex rack" on page 187).
on page 123.
Power supply
Release
latch
Advertisement
Table of Contents
