Table of Contents
Advertisement
10. If you are instructed to return the operator information panel assembly, follow
Installing the operator information panel assembly
Release tabs
Operator information
panel
To install the replacement operator information panel assembly, complete the
following steps:
1. From the front of the server, thread the operator-information-panel ribbon cable
2. Slide the panel into the server until it clicks into place.
3. Inside the server, secure the ribbon cable to the top of the panel enclosure
4. Install the cover (see "Installing the cover" on page 110).
5. Slide the server into the rack.
6. Connect the cables and power cords.
all packaging instructions, and use any packaging materials for shipping that
are supplied to you.
Ribbon cable
Operator information
panel
through the panel housing in the server; then, connect the ribbon cable to the
operator-panel connector (J76) on the system board (see "System-board
internal connectors" on page 13 for the location of the connector).
using the velcro fastener.
Release latch
Chapter 5. Removing and replacing server components
145
Advertisement
Table of Contents
