3. Remove the filler panel from the drive bay.
4. Slide the retention tab and pull the drive out of the drive bay.
5. If you are instructed to return the drive, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Installing a 2.5-inch simple-swap hard disk drive or solid-state
drive
To install a 2.5-inch simple-swap hard disk drive or solid-state drive, complete the
following steps.
1. Touch the static-protective package that contains the drive to any unpainted
metal surface on the outside of the chassis or rack; then, remove the hard disk
drive from the package.
Attention:
Do not press on the top of the drive. Pressing the top might
damage the drive.
2. Align the drive with the guide rails in the drive bay.
3. Slide the retention tab; then, carefully slide the drive into the bay until it stops,
and release the retention tab.
4. Install the filler panel in the drive bay.
5. Turn on the system-board tray (see "Turning on the system-board tray" on page
10).
Chapter 5. Removing and replacing server components
141