Removing And Replacing Frus - IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual

2. If you are replacing the battery cable interposer card, align the battery cable
3. Connect the battery cable to the battery cable interposer card.
4. Align the ServeRAID SAS controller with the connector and the bracket on the
5. Align the storage-riser-card assembly with the guide pins and the slot in the
6. Press the assembly into place on the bracket.
7. Reconnect the signal cables to the ServeRAID SAS controller.
8. Install the top cover (see "Installing the 3U chassis top cover" on page 137).
9. Install the 3U chassis in the iDataPlex rack (see "Installing the 3U chassis top

Removing and replacing FRUs

FRUs must be installed only by trained service technicians.
Note: The illustrations in this document might differ slightly from your hardware.
184
System x iDataPlex dx360 M2: Problem Determination and Service Guide
interposer card with the connector on the ServeRAID SAS controller and press
the interposer card into the connector; then, install the screw to secure the
battery cable interposer card to the ServeRAID SAS controller.
storage-riser-card assembly and press the controller into place.
Attention: When you move the storage-riser-card assembly, do not allow it to
touch any components or structures inside the 3U chassis.
system-board tray cover.
cover" on page 137).