Table of Contents
Advertisement
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices (see "Turning off the system-board
3. If external cables are connected to the front of the system-board tray, note
4. Note where the hard disk drives are installed; then, remove them (see
≥ 18 kg (39.7 lb)
5. Remove the 2 screws and slide the 3U chassis from the iDataPlex rack.
6. Set the 3U chassis on a flat, static-protective surface.
Removing a system-board tray from a 2U chassis
Notes:
1. If two system-board trays are installed in the chassis, they can be removed
2. If an expansion enclosure is installed on the system-board tray, you will remove
on page 23.
tray" on page 21).
where they are connected; then, remove them.
Attention:
When you use RAID arrays, hard disk drives must be installed in
the same location from which they were removed.
"Removing a hard disk drive" on page 30).
Statement 4:
CAUTION:
Use safe practices when lifting.
independently of each other.
the expansion enclosure and the system-board tray from the chassis as one
assembly.
≥ 32 kg (70.5 lb)
Chapter 3. Installing optional devices
≥ 55 kg (121.2 lb)
25
Advertisement
Table of Contents
