Installing The System Board - IBM xSeries 100 Problem Determination And Service Manual

10. If you are instructed to return the system board, follow all packaging

Installing the system board

To install the system board, complete the following steps.
System board
screws (7 places)
88
IBM xSeries 100 Type 8486: Problem Determination and Service Guide
8. Remove the seven screws that secure the system board to the chassis
9. Slide the system board toward the front of the server to disengage the tabs in
the chassis; then, carefully lift the system board out of the server.
instructions, and use any packaging materials for shipping that are supplied to
you.
1. Insert the system board into the chassis and slide it toward the rear of the
server until it fully engages the tabs in the chassis.
Note: The tabs are fully engaged when the screw holes in the system board
are aligned with the corresponding holes in the chassis.
2. Install the seven screws that secure the system board to the chassis.
3. Install any of the following components that were removed from the system
board:
v Battery (see "Installing the battery" on page 65).
v DIMMs (see "Installing a memory module" on page 64).
v Microprocessor and fan sink (see "Installing the microprocessor and fan
sink" on page 85).
v Adapters (see "Installing an adapter" on page 62).
4. Reconnect any cables to the system board that were disconnected during
removal.
5. Install the system fan (see "Installing the system fan" on page 75).