Housing Lower Cover Removal; Housing Lower Cover Left Removal - Epson Stylus Photo895 Service Manual

EPSON Stylus PHOTO 895/785EPX/915/825

4.2.3 Housing Lower Cover Removal

There are two housing lower covers on the right and left sides of a printer.

4.2.3.1 Housing Lower Cover Left Removal

1. Remove the housing from the printer. (Refer to Section 4.2.1 "Housing Removal")
2. Remove two screws (C.B.S. 3x6, F/ZN and C.B.P. 3x8, F/ZN) and detach the Sub
Left Panel Housing from the printer mechanism. (Detach the stacker at the same
time)
Figure 4-10. Sub Left Panel Removal
Tightening torque for screw
• C.B.S 3x6 F/ZN screw for Sub Panel Housing on the printer side:
• C.B.P 3x8 F/ZN screw for Sub Panel Housing on the lower cover side:
Disassembly and Assembly
C.B.S 3x6 F/ZN
C.B.P 3x8 F/ZN
9 +/- 1 kgf.cm
6 +/- 1 kgf.cm
Disassembly
3. Remove three screws (C.B.P. 3x8, F/ZN) from the left housing lower cover and
detach the cover.
C.B.P 3x8 F/ZN
Figure 4-11. Housing Lower Cover Left Removal
Tightening torque for screw
• C.B.P 3x8, F/ZN three screws for housing lower cover: 6 +/- 1 kgf.cm
Revision B
C.B.P 3x8 F/ZN
80