Perkins 404F-22 Engine Specifications - Genie S-40 Service Manual

February 2014
Perkins 404F-22 Engine
Displacement
Number of cylinders
Bore and stroke
Horsepower
Firing order
Low idle
High idle
Compression ratio
Compression pressure
Pressure (psi) of lowest cylinder must
be within 50 psi / 3.45 bar of highest cylinder
Governor
Valve clearance, cold
Intake
Exhaust
Part No. 826364
Lubrication system
Oil pressure
134 cu in
(@ 2000 rpm)
2.2 liters
Oil capacity
4
(including filter)
3.31 x 3.94 inches
Oil viscosity requirements
84 x 100 mm
Below 86°F / 30°C
48 @ 2800 rpm
38 kW @ 2500 rpm
-4°F to 104°F / -20°C to 40°C
1 - 3 - 4 - 2
Above 14°F / -10°C
1300 rpm
Units ship with 15W-40.
229.7 Hz
Extreme operating temperatures may require the use of
alternative engine oils. For oil requirements, refer to the
2500 rpm
Engine Operator Handbook on your machine.
441.7 Hz
Oil pressure sending unit
23.3:1
Oil pressure switch point
426 psi
29.4 bar
Fuel injection system
Injection pump make
electronic
Injection pressure
0.008 in
Fuel requirement
0.2 mm
For fuel requirements, refer to the engine Operator's
0.008 in
Manual on your machine.
0.2 mm
Alternator output
Fan belt deflection
Starter motor
Current draw, normal load
Brush length, new
Brush length, minimum
S-40 • S-45 • S-40 TRAX • S-45 TRAX
Section 2 • Specifications
SPECIFICATIONS
40 to 60 psi
1.4 to 3 bar
9.4 - 11.2 quarts
8.9 - 10.6 liters
5W-20
10W-30
15W-40
14.2 psi
1 bar
Zexel
2133 psi
147 bar
85A @ 12V DC
3
/
8
10 mm
140A - 200A
0.7480 in
19 mm
0.5 in
12.7 mm
2 - 13
in