Rpm Adjustment - Perkins Models; Flex Plate - Genie S-40 Service Manual

Section 4 • Repair Procedures
Engines
5-1
RPM Adjustment - Deutz
D2011L03I Models
Refer to Maintenance Procedure C-7, Check and
Adjust the Engine RPM.
5-2
RPM Adjustment - Perkins
404D-22 Models
Refer to Maintenance Procedure C-7, Check and
Adjust the Engine RPM.
4 - 24
5-3

Flex Plate

The flex plate acts as a coupler between the engine
and the pump. It is bolted to the engine flywheel
and has a splined center to drive the pump.
How to Remove the Flex Plate
1 Disconnect the battery cables from the battery.
2 Disconnect the electrical connectors at the
Perkins models:
3 Remove the engine starter mounting fasteners.
4 Support the drive pump with an appropriate
S-40 • S-45 • S-40 TRAX • S-45 TRAX
Electrocution/burn hazard. Contact
with electrically charged circuits
could result in death or serious
injury. Remove all rings, watches
and other jewelry.
electrical proportional controller, located on the
drive pump.
Remove the starter from the engine. Do not
disconnect the wiring.
lifting device. Then remove all of the bell
housing to engine mounting bolts. Leave the
pump connected to the bell housing.
February 2014
Part No. 826364