Genie S-40 Service Manual page 64

Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
B-17
Test the Alarm Package
(if equipped)
Genie specifications require that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
The alarm package includes:
• Travel alarm
• Descent alarm
• Flashing beacon
Alarms and a beacon are installed to alert operators
and ground personnel of machine proximity and
motion. The alarm package is installed on the
turntable covers.
Note: The alarms and beacon will operate with the
engine running or not running.
1 Turn the key switch to ground control and pull
out the red Emergency Stop button to the on
position at both the ground and platform
controls.
Result: The flashing beacon should be on and
flashing.
2 Move the function enable switch to either side
and activate the primary boom toggle switch in
the down position, hold for a moment and then
release it.
Result: The descent alarm should sound when
the switch is held down.
3 - 30
3 Move the function enable switch to either side
4 S-45: Move the function enable toggle switch to
5 Turn the key switch to platform control.
6 Press down the foot switch. Move the primary
7 Press down the foot switch. Move the
S-40 • S-45 • S-40 TRAX • S-45 TRAX
and activate the secondary boom toggle switch
in the down position, hold for a moment and
then release it.
Result: The descent alarm should sound when
the switch is held down.
either side and activate the jib boom toggle
switch in the down position, hold for a moment
and then release it.
Result: The descent alarm should sound when
the switch is held down.
Result: The flashing beacon should be on
and flashing.
boom control handle to the down position, hold
for a moment and then release it.
Result: The descent alarm should sound when
the control handle is held down.
secondary boom control handle to the down
position, hold for a moment and then release it.
Result: The descent alarm should sound when
the control handle is held down.
October 2014
Part No. 826364