Perform Engine Maintenance - Perkins Models - Genie S-40 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST E PROCEDURES
16 Install a new bearing grease seal into the hub by
pressing it evenly into the hub until it is flush.
17 Slide the hub onto the yoke spindle.
Component damage hazard. Do
not apply excessive force or
damage to the lip of the seal may
occur.
18 Place the outer bearing into the hub.
19 Install the washer and castle nut.
20 Tighten the slotted nut to 35 ft-lbs / 47 Nm to
seat the bearings.
21 Loosen the castle nut and re-tighten to
8 ft-lbs / 11 Nm.
22 Install a new cotter pin. Bend the cotter pin
to lock it in.
Note: Always use a new cotter pin when installing a
castle nut.
23 Install the dust cap, then the tire and wheel
assembly. Torque the wheel lug nuts to
specification. Refer to Section 2, Specifications.
3 - 58
E-3
Perform Engine Maintenance -
Perkins Models
Engine specifications require that this procedure be
performed every 2,000 hours.
All models:
404D-22 models:
Required maintenance procedures and additional
engine information are available in the
Perkins 400 Series Operation Manual
(Perkins part number TPD 1443S)OR the
Perkins 404F Series Operation Manual
(Perkins part number SEBU8609).
Perkins 400 Series Operation Manual
Genie part number
Perkins 404F Series Operation Manual
Genie part number
S-40 • S-45 • S-40 TRAX • S-45 TRAX
• Alternator- inspect
• Engine mounts- inspect
• Starter motor- inspect
• Engine crankcase breather element- replace
October 2014
94890
1251562
Part No. 826364