Genie S-40 Service Manual page 156

Section 5 • Fault Codes
Control System Fault Codes
Error Source
ID Name
Boom 2 flow
33
control valve
Turntable rotate
41
joystick
Turntable rotate
42
directional valves
Turntable rotate
43
flow control valve
Drive enable
44
toggle switch
5 - 4
Error Type
ID Name
12 Value too high
15 Value too low
17 Not calibrated
11 Value at 5V
12 Value too high
15 Value too low
16 Value at 0V
17 Not calibrated
21 Fault
12 Value too high
15 Value too low
17 Not calibrated
21 Fault
S-40 • S-45 • S-40 TRAX • S-45 TRAX
Condition
Valve is operating
outside of operational
limits. Alarm sounds
indicating fault.
Normal function
except threshold for
one or both directions
is zero.
Joystick is operating
outside of operational
limits. Alarm sounds
indicating fault.
Function is inoperative
until joystick is
calibrated.
Valve is operating
outside of operational
limits. Alarm sounds
indicating fault.
Valve is operating
outside of operational
limits. Alarm sounds
indicating fault.
Normal function
except threshold for
one or both directions
is zero.
Drive enable function
is inoperative.
February 2014
Solution
Cycle power off,
then on and
problem should be
corrected.
Calibrate valve
thresholds
Cycle power off,
then on and
problem should be
corrected.
Calibrate joystick
Cycle power off,
then on and
problem should be
corrected.
Cycle power off,
then on and
problem should be
corrected.
Calibrate valve
thresholds.
Cycle power off,
then on and
problem should be
corrected.
Part No. 826364