Traction Manifold Components, 2Wd - Genie S-40 Service Manual

Section 4 • Repair Procedures
MANIFOLDS
7-7

Traction Manifold Components, 2WD

The traction manifold is mounted inside the drive chassis at the non-steer end.
Index
No. Description
1 Relief valve, 280 psi / 19.3 bar ......... GA ........ Charge pressure circuit .................... 30-35 ft-lbs / 41-47 Nm
2 Flow divider/combiner valve ............. GB ........ Controls flow to drive motors
3 Check valve ....................................... GC ........ Drive circuit ....................................... 30-35 ft-lbs / 41-47 Nm
4 Check valve ....................................... GD ........ Drive circuit ....................................... 30-35 ft-lbs / 41-47 Nm
5 Shuttle valve, 3 position 3 way ......... GE ........ Charge pressure circuit that
6 Orifice, 0.070 inch / 1.78 mm ............ GF ......... Equalizes flow across flow
4 - 42
Schematic
Item Function
in forward and reverse ................ 90-100 ft-lbs / 122-136 Nm
directs hot oil out of low pressure
side of drive pump ............................ 50-55 ft-lbs / 68-75 Nm
divider/combiner valve (item GB)
1
GA
S-40 • S-45 • S-40 TRAX • S-45 TRAX
February 2014
Torque
GB
2
GC
3
GD
4
GE
5
GF
6
Part No. 826364