Check The Turntable Rotation Bearing Bolts - Genie S-40 Service Manual

October 2014
D-2
Check the Turntable Rotation
Bearing Bolts
Genie specifications requires that this procedure be
performed every 1000 hours or annually, whichever
comes first.
Maintaining proper torque on the turntable bearing
bolts is essential to safe machine operation.
Improper bolt torque could result in an unsafe
operating condition and component damage.
1 Raise the primary boom and place safety
chocks on the lift cylinders rods. Carefully lower
the boom onto the lift cylinders safety chocks.
Crushing hazard. Keep hands
away from cylinders and all moving
parts when lowering the boom.
Note: The lift cylinder safety chock is available
through Genie (Genie part number 75097).
2 Turn the engine off.
3 Remove the engine tray retaining fasteners
located under the engine tray. Swing the engine
tray out and away from the machine and secure
it from moving.
Crushing hazard. Failure to secure
the engine pivot plate from moving
could result in death or serious
injury.
Part No. 826364
4 Be sure that each turntable mounting bolt is
5 Start the engine form the ground controls.
6 Raise the secondary boom and remove the
7 Lower the boom to the stowed position.
8 Remove drive chassis covers from both the
S-40 • S-45 • S-40 TRAX • S-45 TRAX
Section 3 • Scheduled Maintenance Procedures
CHECKLIST D PROCEDURES
1
10
13
6
18
3
11
20
8
16
2
Bolt torque sequence
torqued in sequence to specifications. Refer to
Section 2, Specifications.
safety chock.
steer end and the non-steer end of the machine.
15
7
19
12
4
17
5
14
9
3 - 47