Check The High Pressure Hydraulic Filter Condition Indicator; Perform 30-Day Service - Genie S-80 Service Manual

Service Manual
Checklist A Procedures
A-8
Check the High Pressure
Hydraulic Filter Condition
Indicator
Genie specifications require that this procedure be
performed every 8 hours or daily, whichever comes
first.
Maintaining the high pressure hydraulic filter in
good condition is essential to good system
performance and safe machine operation. The filter
condition indicator will show when the hydraulic
flow is bypassing a clogged filter. If the filter is not
frequently checked and replaced, impurities will
remain in the hydraulic system and cause
component damage.
1 Open the engine side turntable cover.
2 Start the engine from the ground controls.
3 Change the engine idle to high rpm (rabbit
symbol).
4 Visually inspect the filter condition indicator.
Result: The filter condition indicator should be
operating with the plunger in the green area.
Result: If the indicator displays the plunger in
the red area, this indicates that the hydraulic
filter is being bypassed and the filter should be
replaced. Refer to Maintenance Procedure,
Replace the Hydraulic Filters.
26
A-9

Perform 30-Day Service

The 30-day maintenance procedure is a one time
procedure to be performed after the first 30 days or
40 hours of usage. After this interval, refer to the
maintenance tables for continued scheduled
maintenance.
1 Perform the following maintenance
procedures:
• A-12
Bearing and Rotate Gear
• B-8
Nut Torque
• B-9
Fastener Torque
• B-21
Cables
• D-3
Bearing Bolts
• D-5
Elements
S-80 • S-85 • S-80X
February 2017
Grease the Turntable Rotation
Inspect the Tires, Wheels and Lug
Check the Drive Hub Oil Level and
Inspect the Boom Extend/Retract
Check the Turntable Rotation
Replace the Hydraulic Filter
Part No. 1259369GT