Genie S-40 Service Manual page 121

February 2014
5 Carefully pull the pump and bell housing away
from the engine and secure it from moving.
Component damage hazard. Hoses
can be damaged if they are kinked
or pinched.
6 Remove the flex plate mounting fasteners,
then remove the flex plate from the engine
flywheel.
Ford models:
3 Support the drive pump assembly with an
overhead crane or other suitable lifting device.
Do not apply any lifting pressure.
4 Remove the drive pump retaining fasteners.
5 Carefully pull the drive pump out until the pump
coupler separates from the flex plate.
Component damage hazard. Hoses
can be damaged if they are kinked
or pinched.
6 Disconnect the electrical connector from the
oxygen sensor at the tailpipe. Do not remove
the oxygen sensor.
7 Support the muffler and bracket assembly with a
suitable lifting device.
8 Remove the exhaust pipe fasteners at the
muffler.
Part No. 826364
9 Remove the muffler bracket mounting fasteners
10 Support the engine with an overhead crane or
11 Remove the engine mounting plate to bell
12 Raise the engine slightly using the overhead
13 Remove all of the engine bell housing retaining
14 Carefully remove the bell housing from the
15 Remove the flex plate mounting fasteners.
S-40 • S-45 • S-40 TRAX • S-45 TRAX
Section 4 • Repair Procedures
from the bell housing. Carefully remove the
muffler and bracket assembly from the engine.
other suitable lifting device. Do not lift it.
housing fasteners.
crane and place a block of wood under the oil
pan for support.
fasteners.
engine.
Remove the flex plate from the flywheel.
ENGINES
4 - 25