Perform 30 Day Service - Genie Z-25/8 Service Manual

First Edition • Third Printing
5 Turn the key switch to ground control and pull
out the Emergency Stop button to the
position.
6 Lower the boom to the stowed position.
7 Turn the key switch to platform control and pull
out the Emergency Stop button to the
position at both ground and platform controls.
8 Press down the foot switch.
9 Move the lift/drive select switch (if equipped) to
the drive position.
10 Slowly move the drive control handle off center.
Result: The machine should move at normal
drive speeds.
11 Raise the boom approximately 12 to 14 inches
(30.5 to 35.6 cm).
12 Slowly move the drive control handle off center.
Result: The machine should move at a reduced
drive speed.
Raised Drive speed (maximum)
Boom raised 40 ft/40 sec
Part No. 41314
ON
ON
12.2 m/40 sec
Genie Z-20/8N & Genie Z-20/8 & Genie Z-25/8
Section 4 • Scheduled Maintenance Procedures
TABLE A PROCEDURES
A-10

Perform 30 Day Service

The 30 day maintenance procedure is a one time
sequence of procedures to be performed after the
first 30 days or 50 hours of usage. After this
interval, refer to the maintenance tables for
continued scheduled maintenance.
1 Perform the following maintenance procedures:
· B-3 Inspect the Tires and Wheels
· B-15 Replace the Hydraulic Tank Return
Filter
4 - 9