Genie S-40 Service Manual page 179

February 2014
SPN = Suspect Parameter Number / FMI - Failure Mode Identifier
SPN FMI Description
3713 7 DPF Active Regeneration Inhibited
Due to System Timeout:
Not Responding Properly
3713 31 DPF Active Regeneration Inhibited
Due to System Timeout
3719 0 Particulate Trap #1 Soot Load
Percent: High- most severe (3)
3719 16 Particulate Trap #1 Soot Load
Percent: High-moderate severity (2)
4016 6 High Current Auxiliary Power Relay
1: Current Above Normal
4201 3 Engine Speed Sensor #1:
Voltage Above Normal
4201 4 Engine Speed Sensor #1:
Voltage Below Normal
4201 8 "Engine Speed Sensor #1:
Abnormal Frequency,
Pulse \Nidth, or "Period"
4201 10 Engine Speed Sensor #1:
Abnormal Rate of Change
4765 1 Aftertreatmert #1 Diesel Oxidation
Catalyst Intake Gas Temperature:
Low-most severe (3)
4765 3 Aftertreatmert #1 Diesel Oxidation
Catalyst Intake Gas Temperature:
Voltage Above Normal
Part No. 826364
SPN
4765
4765
4765
5487
5487
6581
S-40 • S-45 • S-40 TRAX • S-45 TRAX
Section 5 • Fault Codes
Perkins 404F-22 Engine Fault Codes
FMI Description
4 Aftertreatmert #1 Diesel Oxidation
Catalyst Intake Gas Temperature:
Voltage Below Normal
15 Aftertreatmert #1Diesel Oxidation
Catalyst Intake Gas Temperature:
High-least severe (1)
16 Aftertreatmert #1 Diesel Oxidation
Catalyst Intake Gas Temperature:
High-moderate severity (2)
3 Aftertreatmert 1 Burner Unit
Combustion Chamber Temperature:
Voltage Above Normal
4 Aftertreatmert 1 Burner Unit
Combustion Chamber Temperature:
Voltage Below Normal
6 Aftertreatmert 1 Hydrocarbon
Doser 2 : Current Above Normal
5 - 27