Perform Engine Maintenance - Perkins Models - Genie S-40 Service Manual

October 2014
13 Remove the filter elements from the housings.
14 Inspect the housing seals and replace them if
necessary.
15 Install the new filter elements into the housings
and tighten them securely.
Note: The medium and high pressure filters use the
same elements.
16 Clean up any oil that may have spilled during the
installation procedure.
17 Use a permanent ink marker to write the date
and number of hours from the hour meter on the
oil filter housings.
18 Start the engine from the ground controls.
19 Inspect the filter housings and related
components to be sure that there are no leaks.
Part No. 826364
D-7
Perform Engine Maintenance -
Perkins Models
Engine specifications require that this procedure be
performed every 1,000 hours.
All models:
404F-22 models:
Required maintenance procedures and additional
engine information are available in the
Perkins 400 Series Operation Manual
(Perkins part number TPD 1443S)OR the
Perkins 404F Series Operation Manual
(Perkins part number SEBU8609).
Perkins 400 Series Operation Manual
Genie part number
Perkins 404F Series Operation Manual
Genie part number
S-40 • S-45 • S-40 TRAX • S-45 TRAX
Section 3 • Scheduled Maintenance Procedures
CHECKLIST D PROCEDURES
• Alternator and fan belts- replace
• Engine valve lash- check/adjust
• Air pump belt- replace
• Crankcase breather canister- replace
94890
1251562
3 - 53