Perform Engine Maintenance - Deutz Models; Inspect The Track Components, Trax Option - Genie S-40 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-6
Perform Engine Maintenance -
Deutz Models
Engine specifications require that this procedure be
performed daily or every 8 hours, whichever comes
first.
Proper engine maintenance, following the engine
manufacturer's maintenance schedule, is essential
to good engine performance and service life. Failure
to perform the maintenance procedures can lead to
poor engine performance and component damage.
All models:
• Oil level- check
• Coolant level- check
• Oil, fuel and coolant systems- check for leaks
• Fuel pre-filter- drain water
• Air filter discharge valve- clean
D 2.9 L4 Models:
• Fuel filter / separator- check/drain
• Exhaust system- inspect
Required maintenance procedures and additional
engine information are available in the
Deutz 2011 Series Operation Manual
(Deutz part number 0312-3547) OR the
Deutz 2.9 L4 Series Operation Manual
(Deutz part number 0312-3893)
Deutz 2011 Series Operation Manual
Genie part number
Deutz 2.9 L4 Series Operation Manual
Genie part number
3 - 10
A-7
Inspect the Track Components,
TRAX option
Note: Genie specifications require that this
procedure be performed daily or every 8 hours,
whichever comes first.
Maintaining tracks and track assembly components
is essential to safe operation and good
performance. A track assembly failure could result
in a machine tip-over. Component damage may
also result if problems are not discovered and
repaired in a timely fashion.
1 Thoroughly clean the track assembly of any dirt,
2 Inspect the following areas for damaged,
• Track
• Idler wheels
• Drive sprocket and hub
• Bogey wheels
• Undercarriage
• Kingpin and steering linkage bushings
139320
1251561
S-40 • S-45 • S-40 TRAX • S-45 TRAX
rocks, clay, etc.
cracked, loose or missing parts and fasteners:
October 2014
Part No. 826364