100 Envelope Feeder
Installing
This section contains two sets of instructions:
• "Installing" (below)
• "Removing" (page 6-34)
1
Unpack the Envelope Feeder and remove packing tape.
2
Rotate the 50 Sheet Bypass Feeder tray up and detach it
from the printer by pulling it UP and OUT.
3
Hold the Envelope Feeder horizontally and insert it into
the bracket where the 50 Sheet Bypass Feeder was
installed. Make sure it is securely attached.
4
Power OFF and ON the printer.
5
Print a Configuration Sheet (see page 3-91) and confirm
that the Envelope Size item appears in the Tray Menu
section of the Configuration Sheet.
Chapter 6: Installing and Removing Printer Options
100 Envelope Feeder
6-33