11
11.8
Using Finisher Manually
The Finisher FS-528/FS-611 with Post Inserter PI-506 installed can be oper-
ated manually, using the operation panel provided on the post inserter.
Place a set of paper into the lower tray. Upper tray cannot be used.
Available output modes according to the optional configuration are de-
scribed below.
- Finisher FS-528/FS-611 + Post Inserter PI-506
–
Staple: Corner (1 staple)/ 2 staples
- Finisher FS-611 + Post Inserter PI-506
–
Staple: Corner (1 staple)/ 2 staples
–
Fold & Staple
–
Multi Tri-Fold
- Finisher FS-528/FS-611 + Post Inserter PI-506 + Punch Kit PK-505
–
Staple: Corner (1 staple)/ 2 staples
–
Punch
- Finisher FS-611 + Post Inserter PI-506 + Punch Kit PK-505
–
Staple: Corner (1 staple)/ 2 staples
–
Fold & Staple
–
Multi Tri-Fold
–
Punch
Reminder
The Z Folding Unit ZU-607 cannot be used for manual punch. To use
Punch mode manually, Punch Kit PK-505 is necessary.
Fold & Staple
Corner staple
11-24
2 parallel staples
Multi Tri-Fold
Output Setting
Start/Stop button
Punch
VarioLink 9522