Supplies & Handling
4.2
Loading Tabbed Sheets
Tabbed sheets are available for copying when loaded in the following trays.
- Main body trays (tray 1 to 3)
- Bypass tray
- Large Capacity Unit LU-407/LU-408
When loading a tray with tabbed sheets, be sure to make the size setting of
the tray to specify a tab paper size to be used. For details, see page 9-44.
Note
The tab extension width should be 12.5 mm or less.
4.2.1
Loading Tabbed Sheets in Main Body Trays (Tray 1 to 3)
Rear
Rear
To load tabbed sheets in tray 1, 2, or 3
1
Withdraw the tray specified for a tab paper size.
2
Open the paper feed roller.
3
Place tabbed sheets on the tray as illustrated above.
4
Move the side guide plates to the edge of the paper.
–
Set paper aligning it to the paper feed roller side of the tray.
–
Press the release lever of the front side guide plate to move the side
guide plates, and also move the rear guide to the edge of paper.
VarioLink 9522
Example: 3 tabbed sheets loaded in position for one finished set
Front
1st TAB
2nd TAB
3rd TAB
Example: 9 tabbed sheets loaded in position for 3 finished sets
Front
1st TABs
2nd TABs
3rd TABs
Printed
side
ONE FINISHED SET
2nd TAB
1st TAB
Printed
side
3rd TAB
3 FINISHED SETS
4
1st TAB
2nd TAB
3rd TAB
4-15