Punching File Holes In Copies - Oce variolink 9522 User Manual

11

11.9.1 Punching File Holes in Copies

Copies will be punched in this mode. Follow the procedure below to select
the paper size 8.5" × 11" v and punch position. To select the punch hole
type, change the die set to the desired one.
!
Detail
For detailed specifications of Multi Punch GP-501, see page 7-10.
Prerequisites
0 Available paper size is 8.5" × 11" v only. Do not use 8.5" × 11" w.
0 A power switch is provided on the multi punch. Be sure to turn it on be-
fore turning on the main and sub power switches of the main body.
0 The die set model currently mounted on the multi punch cannot be
checked from the control panel. If required, open the front door of the
multi punch to check it before the operation.
1
Position the original.
? How should the original be oriented according to the selected
punch position?
% When selecting [Left] or [Right] for the punch position, position the
original lengthwise.
When selecting [Top], position the original widthwise.
2
Touch [Punch] on the Copy Screen.
The Output Application icon shows the punch position currently select-
ed. If you want to change the punch position, proceed to the following
steps.
11-28
Output Setting
VarioLink 9522