Ford 2002 Bantam Workshop Manual page 544

303-01D-40
IN-VEHICLE REPAIR (CONTINUED)
E6447 EN
Engine — 1.8L Diesel - Endura DE
27. Remove the camshaft timing belt.
Installation
1.
NOTE: Running direction of the timing belt
(arrows). Make sure that the timing belt is sitting
centrally on all the timing pulleys.
NOTE: Lubricate the bolt contact face with
engine oil.
NOTE: Make sure that the camshaft timing
pulley can still turn freely on the camshaft.
• Detach the camshaft timing pulley and
take it off with the camshaft timing belt.
• Discard the timing belt.
CAUTION: Always renew the camshaft
timing belt and the fuel pump timing
belt.
CAUTION: Only carry out work on the
timing belt at workshop temperature.
The engine must have been switched off
for at least four hours.
CAUTION: The crankshaft must be
resting against the timing pin and the
timing tool must be inserted in the
camshaft.
Lay a new camshaft timing belt in place.
1. Fit the camshaft timing belt.
2. Locate the camshaft timing pulley and
the camshaft timing belt in installation
position. Tighten the camshaft pulley bolt
finger tight and then undo it a quarter turn.
303-01D-40
09/2001 2002 Bantam