Crankshaft Rear Oil Seal - Ford 2002 Bantam Workshop Manual

303-01B-56
IN-VEHICLE REPAIR

Crankshaft Rear Oil Seal

E6638 EN
Engine — 1.6L / 1.3L RoCam
Removal
1. Remove the transaxle. For additional
information,
2. Remove the clutch. For additional
information,
3. Remove the flywheel.
4. Remove the oil pan. For additional
information,
5. Remove and discard the rear oil seal
retainer and the gasket.
Installation
1. NOTE: An aligning guide is supplied with
each new rear oil seal retainer.
NOTE: The sealing lip must be free of oil.
NOTE: Make sure the aligning dowels are
located.
Install a new rear oil seal retainer.
303-01B-56
refer to Section 308-03.
refer to Section 308-01.
refer to Oil Pan in this section.
07/2001 2002 Bantam