Outer Constant Velocity (Cv) Joint - Ford 2002 Bantam Workshop Manual

205-04-22
REMOVAL AND INSTALLATION

Outer Constant Velocity (CV) Joint

Special Tool(s)
Installer, Halfshaft
204-161 (14-041)
Clamping Tool, Boot
Retaining Clamp
204-169 (14-044)
E6671 EN
Front Drive Halfshafts
General Equipment
32 mm socket
Two-legged puller
High-durability grease
Boot clamps
Removal
1. NOTE: Use an Allen key to prevent the piston
rod turning.
Loosen the left-hand and the right-hand
strut and spring assembly upper retaining
nut five turns (right-hand side shown).
2. Loosen the left-hand wheel nuts and loosen
the stub axle nut.
• Release the front drive halfshaft stub nut
and loosen it with a 32 mm socket
wrench.
3. Raise and support the vehicle. For
additional information,
Material
WSD-M2C230-A
refer to Section 100-02.
07/2001 2002 Bantam
205-04-22
Specification