Ford 2002 Bantam Workshop Manual page 244

206-06-5
REMOVAL AND INSTALLATION (CONTINUED)
E9398 EN
Hydraulic Brake Actuation
4. Disconnect the brake tubes from the brake
master cylinder.
5. Remove the brake master cylinder and
brake fluid reservoir assembly.
1. Remove the nuts.
2. Remove the brake master cylinder.
Installation
CAUTION: Make sure the brake booster
actuator rod is correctly positioned be-
fore installation.
CAUTION: Make sure the brake master
cylinder vacuum seal is correctly posi-
tioned before installation.
1. To install, reverse the removal procedure.
2. Bleed the brake system. For additional
information, refer to Section 206-00.
03/2001 2002 Bantam
206-06-5