No Power In Run; C1: Check Fuse 38 (60A); C2: Check For Short To Ground On Circuit 30 (Rd); C3: Check The Ignition Switch - Ford 2002 Bantam Workshop Manual

211-05-101
DIAGNOSIS AND TESTING (CONTINUED)
PINPOINT TEST C: NO POWER IN RUN
CONDITIONS

C1: CHECK FUSE 38 (60A)

C2: CHECK FOR SHORT TO GROUND ON CIRCUIT 30 (RD)

1.
Fuse 38 (60A)

C3: CHECK THE IGNITION SWITCH

E1227 EN
Steering Column Switches
1.
2.
Ignition relay C47
DETAILS/RESULTS/ACTIONS
2 Check the fuse 38 (60A).
• Is the fuse OK?
Yes
GO TO C3
No
INSTALL a new fuse 38 (60A). TEST the
system for normal operation. If the fuse fails
again GO TO C2
3 Measure the resistance between the fuse 38
connector pin 1, circuit 30 (RD) and ground.
• Is the resistance greater than 10,000 ohms?
Yes
GO TO C1
No
REPAIR circuit 30 (RD). TEST the system
for normal operation.
1 Carry out the ignition switch component test.
Refer to the procedure in this section.
• Does the ignition switch test OK?
Yes
GO TO C4
No
INSTALL a new ignition switch. TEST the
system for normal operation.
211-05-101
07/2001 2002 Bantam