Ford 2002 Bantam Workshop Manual page 162

205-04-29
DISASSEMBLY AND ASSEMBLY (CONTINUED)
E1088 EN
Front Drive Halfshafts
2. Make a clamp head for
• Material: aluminium or steel plate
3. NOTE: Tighten 0,8 mm thick clamping straps
to 12 Nm and 1,1 mm thick clamping straps
to 20 Nm.
Insert the clamping strap in the groove of
the boot and tighten using the special tool.
4. Install the constant velocity joint at the
transmission end.
• Fill the tripod joint with 125 grams of
high-durability grease and fit.
1. Slide a small screwdriver under the boot
seat to allow the air to escape.
2. Slide the tripod joint inwards as far as
the stop, then pull it out 20 mm.
• Remove the screwdriver.
5. NOTE: Tighten 0,8 mm thick clamping straps
to 12 Nm and 1,1 mm thick clamping straps
to 20 Nm.
Insert the clamping strap in the groove of
the boot and tighten with the special tool.
6. NOTE: Make sure the snap-ring snaps
securely into place.
Fit the front drive halfshaft into the halfshaft
joint.
• Slide on the boot with the inner clamping
strap.
• Insert a new circlip into the drive
halfshaft joint groove.
• Insert the front drive halfshaft into the
drive halfshaft joint until the snap-ring
engages.
205-04-29
Special Tool 14- 044.
07/2001 2002 Bantam