Ford 2002 Bantam Workshop Manual page 997

308-03-107
INSTALLATION (CONTINUED)
E6701 EN
Manual Transaxle
All vehicles
34. WARNING: Escaping brake fluid. Do
not allow brake fluid to come into
contact with the skin or the eyes. If
brake fluid does come into contact
with the skin or the eyes, rinse the
affected areas with water
immediately. Failure to follow these
instructions may result in personal
injury.
CAUTION: If brake fluid is spilt on the
paintwork, the affected area must be
immediately washed down with cold
water.
Install the clutch slave cylinder high-
pressure line.
• Insert the clutch slave cylinder high-
pressure line in the bracket.
35. Bleed the clutch hydraulic system . For
additional information,
Vehicles with 1.6L / 1.3L engine
36. Install the air cleaner (ACL) intake pipe.
Vehicles with diesel engine
37. Install the air cleaner intake hose.
1. Install the resonator pipe (clip).
2. Install the intake pipe to the air cleaner
housing.
3. Install the clip.
4. Install the air cleaner housing to the
intake manifold.
308-03-107
refer to Section 308- 00.
07/2001