Ford 2002 Bantam Workshop Manual page 329

211-02-68
REMOVAL AND INSTALLATION (CONTINUED)
E5861 EN
Power Steering
12. Using the special tools, align the
crossmember.
1. Insert the guide pins through the
crossmember alignment holes.
2. Slide the locking plate into the grooves
and tighten the alignment pin sleeves.
3. Raise the crossmember engaging the
guide pins into the chassis aligning holes.
13. Install the crossmember retaining bolts.
14. Install the rear support insulator to
transmission bolt.
15. Remove the transmission jack and
alignment pins.
16. NOTE: Install a new gasket and nuts.
211-02-68
07/2001 2002 Bantam