Auto Layout - Fuji Xerox ApeosPort-V C5575 Administrator's Manual

16 Appendix

Auto Layout

This section explains Auto Layout.
What is Auto Layout?
Auto Layout is a function that evaluates document size using the HP-GL data entered from
a host system and enlarges or reduces the document size corresponding to the paper size so
that data plotted is placed in the center of the paper. Using the Auto Scaling/Auto Layout
function enables you to print a document in the HP-GL mode without concern for document
size and origin position.
All Auto Layout settings can be made in the [HP-GL/2 - Programming] screen (Select the
<Machine Status> button > [Print Mode] > [HP-GL/2 Emulation] > [Programming]). The
settings cannot be made with advanced commands.
Enabling Auto Layout
To enable Auto Layout, enter Item Numbers and Values on the [HP-GL/2 - Programming]
screen as follows:






Setting Item Details
The following describes the details for each setting. You can change the settings on the [HP-
GL/2 - Programming] screen.
 Document Size
To set Document size to Auto, enter [101] to the [Item Number] box and select [Change
Value], and then enter [99] to the [New Value] box and select [Save]. Once you set
Document size to Auto, you can set Auto layout to ON.
 Auto Layout
To set Auto layout to ON, enter [106] to the [Item Number] box and select [Change Value],
and then enter [0] to the [New Value] box and select [Save]. Enabling Auto layout activates
the settings for scaling, area determination mode, paper margins, and scaling mode.
 Scaling
Set whether the original size is enlarged or reduced so that the document size fits the paper
size.
16
 Area Determination Mode
The following methods are available to obtain an active coordinates area using HP-GL data.

708
Set [Document size ([101])] to [Auto ([99])]. The default value is [Auto ([99])].
Set [Auto layout ([106])] to [ON ([0])] to set the origin position. The default value is [ON
([0])].
Set [Scaling ([159])] to [ON ([1])]. The default value is [ON ([1])].
Select a method for obtaining the active coordinate area using the area determination
mode. The default value is [Auto ([0])].
Set the paper margin using [Paper margin ([162])]. The default value is 0 mm ([0]).
Set the scaling mode. The default value is [Paper Size ([0])].
Auto
Automatically selects the method of determining the active coordinates area from PS,
IW, IP, and Adapted in that order of priority.