Fuji Xerox ApeosPort-V C5575 Administrator's Manual page 585

Error Code
116-714 [Cause] An HP-GL/2 command error occurred.
[Remedy] Check the print data.
116-716 [Cause] An error occurred when reading the data on the media.
116-717
[Remedy] On a computer, confirm the content recorded on the media.
116-720 [Cause] An error occurred during print processing because of insufficient memory.
[Remedy] Stop unnecessary ports or delete unnecessary data to free up disk space.
116-725
[Cause] Failed to write the image log because the image log storage area on the machine is
insufficient.
[Remedy] Execute the operation again.
If this error still is not resolved, take one of the following measures:


In this case, selecting [Low] does not secure the contents of created image logs.
116-738 [Cause] The size and orientation of the form specified are not matched with the paper to be
printed.
[Remedy] Match the size and orientation of the paper with the form specified, and print again.
116-739 [Cause] The form or logo data cannot be registered because memory for the form and logo data
or memory capacity for the hard disk is insufficient.
[Remedy] Delete unnecessary data, or free up the space for the form memory.
116-740 [Cause] A numerical value operation error occurred because a value exceeding the value limit of
the machine was used in the print data.
[Remedy] Check the print data.
116-741 [Cause] The form cannot be registered because the number of the form registration exceeds the
maximum number allowed.
[Remedy] Delete unnecessary form. The maximum number allowed is 2048.
116-742 [Cause] The logo data cannot be registered because the number of the logo data registration
exceeds the maximum number allowed.
[Remedy] Delete unnecessary logo data.
116-743 [Cause] The logo data or form cannot be registered because the memory for the form and logo
data is insufficient.
[Remedy] Increase memory.
116-746
[Cause] The form specified is not registered.
[Remedy] Use the form registered, or register the form.
116-747 [Cause] The paper margin value is too large for the HP-GL/2 active coordinates area.
[Remedy] Decrease the paper margin value, and then execute the operation again.
116-748 [Cause] There is no plot data in the HP-GL/2 print data.
[Remedy] Check the print data.
116-749 [Cause] The job was cancelled because the specified font does not exist.
[Remedy] Install the font, or set the print driver to replace the font.
116-750 [Cause] Banner sheet tray malfunction
[Remedy] Restore the tray to normal condition or change the Banner sheet tray.
Cause and Remedy
Delete unnecessary image logs.
Change the [Assurance Level] setting for image logs to [Low].
Error Code
15
585