Installation Procedures; Step 1 Enabling Port And Setting Up Tcp/Ip - Fuji Xerox ApeosPort-V C5575 Administrator's Manual

Installation Procedures

This section describes the configuration procedures to use the IP Fax (SIP) feature on the
machine.
The following shows the reference section for each procedure.

Step 1 Enabling Port and Setting up TCP/IP .........................................................................................................................391

Step 2 Configuring the SIP User Name...................................................................................................................................392
Step 3 Configuring Fax Environment ......................................................................................................................................392
Step 4 Configuring the SIP Server............................................................................................................................................393
Step 5 Registering the VoIP Gateway .....................................................................................................................................394
Step 1 Enabling Port and Setting up TCP/IP
To use the IP Fax (SIP) feature on the machine, enable the port and set the IP addresses.
The following shows the configuration procedures on the machine.
You can configure the settings using CentreWare Internet Services. For information on how to use CentreWare Internet
Services, refer to "Configuring Machine Settings Using CentreWare Internet Services" (P.339).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note
3) Select [Tools] on the Services Home screen.
2
Enable the SIP port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SIP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining the
address. If an IP address cannot be obtained automatically, or if manual configuration is
preferred, confirm the settings of an IP address, a subnet mask, and a gateway address.
For information on how to set an IP address, refer to "Protocol Settings" (P.221).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].
Note
6
Print a configuration report to confirm that the port is enabled and TCP/IP setting is set up
correctly.
• The default user ID is "11111".
• The default passcode is "x-admin".
• Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.
Installation Procedures
391
10