Fuji Xerox ApeosPort-V C5575 Administrator's Manual page 592

15 Problem Solving
Error Code
127-310 [Cause]
127-311
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
127-312
127-313
127-314
127-315
127-320
127-337
127-342
127-353
127-354
127-396
127-398
127-399 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
127-700 [Cause]
[Remedy] Check if the SIP registrar server is available. Also, confirm that [SIP Registrar Server
133-210 [Cause]
133-211
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
133-212
133-213
133-214
133-215
133-216
133-217
133-218
133-219
133-220
133-221
133-222
133-223
133-224
133-226 [Cause]
15
[Remedy] Contact our Customer Support Center.
133-280 [Cause]
133-281
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
133-282
133-283
133-700
[Cause]
[Remedy] Check whether the staple/hole punch position is correct, and then execute the operation
592
Cause and Remedy
An error occurred in the machine.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
An error occurred in the machine.
on the machine power. If the same message is displayed again, switch off the machine
power again, and then switch on the machine power while pressing the <Start> button
and <Stop> button simultaneously, and hold this condition for 6 seconds. The print data
that caused an error will be deleted automatically, and the machine reboots. If the error
still is not resolved, contact our Customer Support Center.
The SIP registrar server cannot be used.
Setup] is set correctly under [Tools] > [System Settings] > [Connectivity & Network
Setup] > [SIP Settings] > [SIP Registrar Server Setup].
An error occurred during fax transmission.
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
A country code not supported by the machine was specified.
An error occurred during fax transmission.
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
The staple/hole punch setting was cancelled.
again.