Fuji Xerox ApeosPort-V C5575 Administrator's Manual page 514

15 Problem Solving
Error Code
016-751 [Cause]
[Remedy] For 1), use the print driver to print the document.
For more information on the memory, refer to "Allocate Memory" (P.244).
016-752 [Cause]
[Remedy] Change the [Image Quality] setting from [High Resolution] to [High Quality], or from
016-753 [Cause]
[Remedy] Set the correct password on ContentsBridge.
016-755 [Cause]
[Remedy] Cancel the print protection using Acrobat
016-756 [Cause]
[Remedy] Consult your system administrator.
016-757
[Cause]
[Remedy] Enter the correct passcode.
016-758 [Cause]
[Remedy] Consult your system administrator.
016-759 [Cause]
[Remedy] Consult your system administrator.
016-760 [Cause]
[Remedy] Take one of the following measures:
For more information on [Image Quality], refer to the help of the print driver. For more information on memory, refer to
"Allocate Memory" (P.244).
016-761
[Cause]
15
[Remedy] Set [Image Quality] to [Standard] and execute the operation again. If the error still is
016-762 [Cause]
[Remedy] For [Parallel] and [USB] in [Print Mode] under [Port Settings], specify correct printer
016-763 [Cause]
[Remedy] Confirm the POP server IP address set on the machine.
514
Cause and Remedy
Probable causes are as follows:
1)During the PDF Bridge processing, a syntax or parameter error occurred, an undefined
command was used, and a PDF file was damaged.
2)When [Print Processing Mode [408])] for the PDF Direct Print feature has been set to
[PS([1])], memory is insufficient.
3)When [Print Processing Mode [408])] for the PDF Direct Print feature has been set to
[PS([1])], a PDF file including OpenType fonts is processed.
For 2), take one of the following measures:
 Use the print driver to print the document.

Increase PostScript memory.
For 3), create a PDF file in which OpenType fonts are not included.
Unable to process for PDF Bridge because of insufficient memory space.
[High Quality] to [Standard]. Or, add memory.
The password entered does not match that of the PDF file.
Attempted to process a print-protected PDF file.
Do not have permission to use the service.
The passcode is incorrect.
The division does not have permission to use the service.
The number of pages reached the maximum number of pages for this service.
An error occurred during PostScript (optional) processing.

Set [Image Quality] to [High Speed].

Increase PostScript memory.
An error occurred during image processing.
not resolved, set [Print Page Mode] to [On].
The specified printer language is not installed on the machine.
language.
Unable to connect to the POP server.
® ®
Reader , and try printing again.