Fuji Xerox ApeosPort-V C5575 Administrator's Manual page 28

1 Before Using the Machine
4
Select [System Settings] > [Common Service
Settings] > [Power Saver Settings].
5
Select [Power Saver Timers], and then select
[Change Settings].
1
6
Using [ ] and [ ], set the time to elapse until
entering the Power Saver mode, in 1 minute
increments.
 From Last Operation to Low Power Mode
Set the time to elapse from the last operation until the machine enters the Low Power mode.
Note
 From Last Operation to Sleep Mode
Set the time to elapse from the last operation until the machine enters the Sleep mode.
Note
7
Select [Save].
8
Select [Close] repeatedly until the [Tools] screen is displayed.
9
Select [Close].
28
• The default value for [From Last Operation to Low Power Mode] is 1 minute. You cannot disable the
Low Power mode.
• The timer does not start counting until the operator leaves the detectable area of Smart
WelcomEyes. The Access Lamp is lit while the machine detects human presence.
• The default value for [From Last Operation to Sleep Mode] is 1 minute. To make the machine enter
the Low Power mode, set a longer period of time for [From Last Operation to Sleep Mode] than for
[From Last Operation to Low Power Mode].
• The timer does not start counting until the operator leaves the detectable area of Smart
WelcomEyes. The Access Lamp is lit while the machine detects human presence.