Fuji Xerox ApeosPort-V C5575 Administrator's Manual page 586

15 Problem Solving
Error Code
116-751 [Cause]
[Remedy] Delete stored data in the hard disk. If the error still is not resolved, split the file and send
116-752
[Cause]
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Note
116-771
[Cause]
116-772
[Remedy] The printed image may be incomplete. Confirm with the sender whether the image has
116-773
116-774
116-775
116-776
116-777
116-778
116-780 [Cause]
[Remedy] Check the attached document.
116-790 [Cause]
[Remedy] For 1), manually staple the first set of the document. Or, do not cancel printing of a
117-311 [Cause]
[Remedy] Insert Data Security Kit into the correct slot.
117-312 [Cause]
[Remedy] Contact our Customer Support Center.
117-319 [Cause]
117-320
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
117-321
117-322
117-323
15
117-324
117-326
117-326
117-327
117-329
117-331
117-332
117-333
117-334
586
Cause and Remedy
The process has been canceled because the hard disk is full.
the job again.
The descriptions of the PDF or XPS printing job ticket have a problem.
Support Center.
• XPS stands for XML Paper Specification.
The data was automatically modified because it included an invalid parameter.
a problem, or ask the sender to send the data again. When using the Internet Fax
Forwarding feature, confirm its condition with the e-mail recipient.
There is a problem with the document attached to the received e-mail.
Probable causes are as follows:
1)If the operator cancelled printing a document that was received using the Store Fax -
Local Folder or Store Internet Fax - Local Folder feature:
The first set of the document is not stapled.
2)For causes other than 1)
No set of the document is stapled.
document that is received using the Store Fax - Local Folder or Store Internet Fax - Local
Folder feature.
For 2), check whether the staple position has been correctly specified, and try printing
again.
Data Security Kit is not attached correctly.
An error occurred in the machine.
An error occurred in the machine.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.