Fuji Xerox ApeosPort-V C5575 Administrator's Manual page 518

15 Problem Solving
Error Code
017-717 [Cause]
[Remedy] Use the valid SSL server certificate of the SMTP server. You can avoid this error by
017-718 [Cause]
[Remedy] Use the valid SSL server certificate of the SMTP server. You can avoid this error by
017-719
[Cause]
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
017-723 [Cause]
[Remedy] Print the file from DocuWorks Viewer via the PCL print driver.
017-724
[Cause]
[Remedy] Confirm whether the machine is compatible with Denshi-Pen. When it is compatible,
017-725
[Cause]
[Remedy] Incorrect name is set for the template of the Force Annotation. Confirm the name of the
017-729 [Cause]
[Remedy] Take one of the following measures:
017-730 [Cause]
[Remedy] Confirm the followings:
017-731 [Cause]
15
[Remedy] Confirm the followings:
017-732
[Cause]
[Remedy] Press the <Machine Status> button of the storage destination machine, and set [Print
518
Cause and Remedy
SMTP server SSL server authentication error. The server certificate expired.
setting [SMTP-SSL/TLS Communication] under [SSL/TLS Settings] to [Disabled],
however the validity of the server cannot be warranted.
SMTP server SSL server authentication error. The server name and certificate do not
match.
setting [SMTP-SSL/TLS Communication] in [SSL/TLS Settings] to [Disabled], however
the validity of the server cannot be warranted.
SMTP server SSL server authentication error. SSL authentication internal error.
Support Center.
Character strings the DocuWorks Direct Print feature does not support are used.
An error occurred while receiving a print job from Denshi-Pen.
execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
An error occurred while receiving a print job when the Force Annotation is enabled.
template registered in the machine.
When the machine is used as a print job storage device, print job sending was stopped
temporarily because the number of jobs in the machine exceeded the maximum
receivable volume or the space for spool data was insufficient.

Set to spool data to the hard disk from the setting of the storage destination machine.

Set [IPP] under [Properties] > [General Setup] > [Memory Settings] to [Spool to Hard
Disk] by CentreWare Internet Services.

Wait for a while and send the job again.
When the machine is used as a print job storage device, the computer failed to send a
job to the machine because a network error occurred.

The network cable is connected properly.

The storage destination machine is powered on.

The IPP port of the storage destination machine is enabled.
If the error still is not resolved, contact our Customer Support Center.
Unable to connect to the POP server.

The IP address of the POP server is set on the machine.

The network cable is connected properly.
When the machine is used as a print job storage device, the computer failed to send a
job because the machine is off-line.
Mode] to [On-line] on the [Machine Information] screen. If the error still is not resolved,
contact our Customer Support Center.