Fuji Xerox ApeosPort-V C5575 Administrator's Manual page 511

Error Code
016-711 [Cause] The upper limit for the e-mail size has been exceeded.
[Remedy] Take one of the following measures, and then try sending the mail again.





016-712 [Cause] Unable to process the document because the specified scan area is too small.
[Remedy] Increase the resolution or scan area.
016-713
[Cause] The passcode entered does not match the passcode set on the folder.
[Remedy] Enter the correct passcode.
016-714 [Cause] The specified folder does not exist.
[Remedy] Create a new folder or specify an existing folder.
016-715 [Cause] The machine failed to access the ESCP form because the password of the ESCP form
does not match.
[Remedy] Enter the correct password of the ESCP form.
016-716 [Cause] Unable to spool TIFF file because of insufficient hard disk space.
[Remedy] Delete unnecessary files and users from the machine, or install the hard disk. For
information on installing the hard disk, contact our Customer Support Center.
Refer to "11 Job Status" > "Printing and Deleting Stored Jobs" in the User Guide.
016-717 [Cause] Unable to create a Transmission Report - Job Undelivered or a Transmission Report
because the transmission result information required for creating the report is not
stored in the machine's memory.
[Remedy] Take one of the following measures:



016-718
[Cause] Unable to process the PCL print data because of insufficient memory.
[Remedy] Reduce the resolution, or cancel 2 sided printing or N up feature, and then print again.
016-719 [Cause] Unable to process the PCL print data because of insufficient print page buffer.
[Remedy] Increase the size of the print page buffer.
016-720 [Cause] An invalid command is included in PCL print data.
[Remedy] Confirm the print data and try printing again.
016-721 [Cause] An error occurred during print processing. Probable causes are as follows:
1)Printing was instructed by the Auto Paper selection when [Paper Type Priority] is set
2)ESC/P-K command error occurred.
[Remedy] For 1), when printing by the Auto Paper selection, set one of the paper types to other
than [Auto Paper Off] in [Paper Type Priority].
For 2), confirm the print data.
Refer to "Paper Type Priority" (P.172).
Cause and Remedy
Reduce the number of pages of the document.
Lower the resolution with [Resolution].
Reduce the magnification with [Reduce/Enlarge].
Ask your system administrator to increase the value set for [Maximum Total Data
Size].
For color scanning, set [MRC High Compression] to [On] under [File Format].
Execute the jobs for large size Internet fax documents (about 2GB) by splitting each
document to minimize memory or HDD usage.
If many scan or Internet fax documents are being processed, wait until the jobs are
completed to execute a new job.
After completing the job that you want to confirm in a report, do not execute 200 or
more jobs before printing the report.
to [Auto Paper Off] for all paper in the [Common Service Settings].
Error Code
15
511