Fuji Xerox ApeosPort-V C5575 Administrator's Manual page 570

15 Problem Solving
Error Code
033-718 [Cause]
[Remedy] Store fax or polling documents into the folder as necessary.
033-719 [Cause]
[Remedy] Retry sending.
033-721 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
033-724
[Cause]
[Remedy] Install the Extension System Memory to increase the maximum volume of image data.
033-725 [Cause]
[Remedy] Delete unnecessary data from the hard disk to free up disk space.
033-726 [Cause]
[Remedy] No measure is required.
033-728 [Cause]
[Remedy] No measure is required. The machine will automatically start the auto print job after
033-731 [Cause]
[Remedy] The auto print processing of the received fax document was interrupted by a manual
033-732
[Cause]
[Remedy] This is an error occurring during maintenance work by Fuji Xerox. No measure is
033-733 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
033-734
[Cause]
[Remedy] No measure is required.
033-735 [Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
15
033-736 [Cause]
[Remedy] No measure is required.
033-737
[Cause]
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
033-738 [Cause]
[Remedy] No measure is required.
570
Cause and Remedy
Fax or polling documents do not exist in the folder specified from the sender's machine.
The document may be deleted by turning the machine off and then on.
An error occurred during fax transmission.
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
The reception was interrupted because the image volume exceeded the upper limit.
The hard disk is full.
The received document was printed with 1 sided printing, because 2 sided printing is not
available for mixed sized documents.
The auto print formatting of the received fax document was interrupted by a manual
print operation.
manual printing completes.
The printing of the received fax document was interrupted.
print operation. No measure is required.
An error occurred while connecting to the EP system.
required.
An error occurred during fax transmission.
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
Because a report job was instructed while preparing to print a received fax, the printing
of the received fax is temporarily suspended.
An error occurred during fax transmission.
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
The forwarding job was interrupted because the data volume exceeded the upper limit.
An error occurred during fax transmission.
Support Center.
Received abnormal JBIG data.