Fuji Xerox ApeosPort-V C5575 Administrator's Manual page 496

15 Problem Solving
Error Code
003-795 [Cause]
[Remedy] Take one of the following measures:
005-275 [Cause]
005-280
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
005-500
010-330 [Cause]
010-360
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
010-361
010-362
010-363
010-364
010-367
010-368
010-369
010-370 <ApeosPort-V C5575/C4475/C3375/C3373/C2275, DocuCentre-V C5575/C4475/C3375/
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
<ApeosPort-V C7775/C6675, DocuCentre-V C7775/C6675>
[Cause]
[Remedy] Confirm the following.
010-371
[Cause]
010-372
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
010-373
010-374
15
010-375
010-376
010-377
010-378
010-379
010-380
010-381
010-382
010-398
496
When enlarging/reducing a scanned document to the paper size specified, the
reduction/enlargement ratio exceeds the allowed range.
 Manually enter a reduction/enlargement ratio.

Change the paper size.
An error occurred in the document feeder.
on the machine power. If the error still is not resolved, contact our Customer Support
Center.
An error occurred in the machine.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
C3373/C2275>
An error occurred in the machine.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
An error occurred in the machine.

Two power codes are connected to the outlets.

Two power codes are connected to the machine.

Circuit breakers of the machine are ON.

Breakers on switchboards are not tripped.
After confirming the above items, switch off the machine power, make sure that the
touch screen is blank, and then switch on the machine power. If the same message is
displayed again, contact our Customer Support Center.
An error occurred in the machine.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
Cause and Remedy